How Electricians in South Jersey Perform Radon System Installation in a New Construction?

Many of you would probably be finding so many of the issues when it comes to the radon system installation in some new construction places. You might do not know the fact that the passive radon mitigation process can be a life-saving. If you are constructing your home for the first time, then you can make it build upon with the radon-resistant on the permanent basis. You can make it get all installed with the passive radon system on the finest basis.

For the readers, it is to be highlighted that in any radon system installation by electricians in South Jersey, it does involve 6 basic and primary components for you. Check them out one by one:

List of Important 6 Components of Radon System Mitigation Installation:

Component No 1: Gas Permeable Layer:

Before pouring the concrete slab, you should importantly be installing the permeable layer into it. You should be installed with about 6 layers of the clean radon gravel.  It is to be added that gravel is porous and it would let the easy movement of the air.  There air movement will be carried out as below the concrete slab.

Component No 2: Vapor Barrier:

On the second, we would mention about the vapor barrier that would be located above the portion of the gad permeable layer. This would be installed as before you do pour the concrete slab. You can eventually make the coverage use of the 10 mil barrier that would be premium much as in regard to the least 6mil visqueen.

Component No 3: Radon Collection Point:

In the third of the component list of radon system installation by Electricians in South Jersey , we would be mentioning you about the installation of radon collection point. This installation will be done by means of the schedule of 40 PVC pipe stub.  This installation will be made successful by covering the soil gas collection pipe.

Component No 4: Seal Radon Entry Points:

You need to seal off the radon entry points. By the way of using the proper concrete caulk, it is much important to hence seal with all the appeared cracks which you might view on the concrete floor or the control joints.  If you do witness a slump in your home, then you should be covering it with the sealing of airtight by means of sump cover. As you are all done with the plumbing work, you should be sealing all the regions of the pipes by the access of expandable foam sealant.

Component No 5: Install Radon Radon Vent Pipe:

Over the next, you should be installing the radon vent pipe.  When you are all set with the radon system installation, you should also make sure that you did installed the radon vent pipe too. As the whole home gets warm with the pipe, it would be showing out the effect of pulling the air right through the pipe.

Component No 6: Install Electrical Junction Box:

Lastly, of the radon system installation, it’s time to work with the installation of the electrical junk box. You should be carrying out its installation as within the reachable distance straight into the radon vent pipe into the attic. It would let you figure out that the system has been all activated.

So these have been few of the main components that do play an important role in the radon system installation by the Electricians in South Jersey in a new construction. Was this blog informative for you?

Leave a Reply

Your email address will not be published. Required fields are marked *